How to
install your Leading Edge bladder
1. This
works best with a friend to help
2. Lay
your kite out, struts up. Be sure to lay the LE flat so it looks
like the bladder to avoid twists
3. Lay
the bladder out flat.
4. Fold
the bladder, accordion style from the middle to the ends.
5. Place
the bladder on the leading edge to one side of the access opening.
6. Tie
one of the lines to one tip of the bladder.
7. One
person at the tip to pull the bladder thru.
8. The
other person at the access to feed the bladder flat and strait.
9.
When the bladder
comes thru the tip stop pulling.
10.
Now move the folded half of the bladder to the other side of
the access.
11.
Pull the other side thru.
12.
Secure the tips as they were originally installed.
13.
Put the valves into place, being careful to not create any
twists.
14.
Close the access velcro or zipper.
Tips for pumping up your kite
1. Pump
up about ¾ of the way.
2. Check
for wrinkles or twists before continuing.
3. If
there are any twists or voids you will blow bladder.
4. Also
if the bladder is not seated properly the steering will be affected.
5.
When the orientation looks good, slowly pump up and check as
you go.
6. Moving
and shaking the leading edge seems to help.
7. Sometimes
there is no other option other than reinstalling.
You
may pay with personal check, PayPal, postal money order.
Contact information
Jim
Haddox
58 Seaview
Drive
Ormond Beach, FL 32176
Email
mailto:jhaddox@cfl.rr.com
Phone
386-847-0483
|