How to
install strut bladders
1. Fold the hip of the bladder inside itself.
(If you do not do this the bladder will fold under and not fill the
hip)
2. Note the orientation of the plug/flap on the valve.
3. Pull the strut thru being sure not to twist.
4. Push the valve a bit beyond the hole with your finger, then align
and pull valve into place.
5. Do not tug on the tip of the bladder there needs to be excess
inside.
6. Fold the tip, being sure there is excess inside.
7. Secure the tip with the Velcro.
8. Pump up 2/3 of the way.
9. Be sure that you can feel bladder in all cavities of the sleeve,
even with low pressure.
(You may need to massage and or shake the strut to get it seated
properly)
10. Pump up 8/10 of the way.
11. Check that there is bladder in all cavities.
12. Pump it tight.
Tips for pumping up your kite
1. Pump
up about ¾ of the way.
2. Check
for wrinkles or twists before continuing.
3. If
there are any twists or voids you will blow bladder.
4. Also
if the bladder is not seated properly the steering will be affected.
5.
When the orientation looks good, slowly pump up and check as
you go.
6. Moving
and shaking the leading edge seems to help.
7. Sometimes
there is no other option other than reinstalling.
Contact information
Jim
Haddox
58 Seaview
Drive
Ormond Beach, FL 32176
Email
mailto:jhaddox@cfl.rr.com
Phone
386-847-0483
|